Lennox E207 Error Code: Hot surface igniter open
Updated October 2026 · Sourced from Lennox documentation
🛑 Turn it off and call a licensed pro
The hot surface igniter (HSI) is sensed as open, so the burners cannot be lit. It is listed as a 60 minute soft lockout fault.
Is it safe to keep running? No. Turn it off and get it checked. Call a licensed HVAC technician. The igniter is fragile and must be tested and replaced by a professional.
E207 at a glance
| Code / how it shows | Meaning | Applies to |
|---|---|---|
| E207 Shown as an E code on the 7-segment display of the integrated control | Hot surface igniter open | Lennox SL280UHVK two-stage variable-speed furnace (integrated control, 7-segment display) |
Check this first
Only steps a homeowner can do safely. Do not open electrical panels or the burner area.
- Turn the furnace power switch or breaker off for 30 seconds, then back on, and see if the code clears.
- Check the thermostat is set to Heat, set above room temperature, and has fresh batteries if it uses them.
🛑 Stop and call a licensed pro if
- Call a licensed HVAC technician. The igniter is fragile and must be tested and replaced by a professional.
- You smell gas. Leave the house, do not touch switches, and call your gas utility from outside.
- Flame rollout, limit or pressure switch codes that come back after one reset.
- Anything involving the control board, gas valve, flame sensor, igniter or venting.
- A carbon monoxide alarm sounds. Get everyone outside and call 911 or the fire department.
Safe first steps for any Lennox code
- Count the LED flashes through the blower door window before you switch anything off. Cutting power can clear the code.
- Replace or clean the furnace air filter.
- Check the thermostat: correct mode, set above room temperature, and fresh batteries.
- Make sure the furnace power switch and breaker are on. If the furnace has locked out, turning the power off and back on once restarts it.
- Make sure the gas valve is in the ON position, following the lighting instructions on the furnace label only.
- On high-efficiency furnaces, look at the outside vent and intake pipes for snow, ice, leaves or nests (look only, do not take pipes apart).
Source: Lennox SL280UHVK Installation Instructions 508553-01 (01/2025), Ignition Control Diagnostic Codes (continued), p.37. Codes are series-specific, so your unit's own manual is the final word. Reviewed October 2026.
Shaun Cain · Certified HVAC & Refrigeration Technician · Ask an HVAC technician
Related Lennox codes
E110 : AC line voltage lowE111 : Line voltage polarity reversedE112 : Earth ground not detectedE113 : AC line voltage highE115 : Low 24V control voltageE200 : Rollout open (hard lockout)E204 : Gas valve relay problemE206 : Gas valve second-stage relay problemE223 : Low pressure switch failed to closeE224 : Low pressure switch failed to openE225 : High pressure switch failed to closeE226 : High pressure switch failed to open